SureCuts with upgraded computer.

[George2014 6]

Upgraded my computer to Windows 10 and now SureCuts wants to register again.

Unfortunately i had gotten the serial # with my cutter so their website can not find my serial # by email. 

 

The same goes with SignBlazer except there is no site anymore to register....

 

Is there a cure?

 

Thanks

 

[mb20music 760]

I don't know about the SCALP issue but I think re-installing SBE should work, this link should work for downloading SignBlazer Elements.

 

http://support.uscutter.com/index.php?/Knowledgebase/Article/GetAttachment/190/23340

[slice&dice 2,450]

The best link for the SignBlazer program (NO-TRIAL version) is this one --

http://support.uscutter.com/index.php?/Knowledgebase/Article/GetAttachment/190/24198

 

Also, I believe you would be well-served to spend $30 to obtain the cutting/design program VinylMaster and ditch SCALP.

http://www.uscutter.com/VinylMasterCutSoftware-Upgrade

 

If you just have to keep using SCAL, then maybe talk to USCutter Support and request a replacement disk with a new serial #.

[MadHatterGraphix 1,258]

If you registered your Sure cuts a lot it should be on file.

[busterbay 326]

Upgraded my computer to Windows 10 and now SureCuts wants to register again.

Unfortunately i had gotten the serial # with my cutter so their website can not find my serial # by email. 

 

The same goes with SignBlazer except there is no site anymore to register....

 

Is there a cure?

 

Thanks

 

 

The same thing happened to me on one of my computers. If you registered the software Craft Edge will have it on file, they reset my installs back to zero for me.

[ScrappyDew 0]

Go here: https://www.craftedge.com/activation/scal/activate.php

It will tell  you that you have too many registered copies (which is ok) because you will be able to reset your number automatically on the next screen that shows up.

[TT57 135]

Hey ScrappyDew - welcome to the usc forum