tuctucben 0 Posted March 12, 2015 Hi. I'm new to this. I'm working on getting everything setup, configured and tested. I'm using a pen for some initial testing. I have Sure Cuts A Lot Pro 3, and I'm using a USCutter LaserPoint for cutting. I'm trying to test with just a basic shape. I create my shape and I send it to the cutter, then all I see the cutter do is make a line and then it's done. Does anyone have ideas on why this might be happening? Thanks! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted March 12, 2015 Did you activate the Sure Cuts a lot? You have to, or it will be in demo mode. Share this post Link to post Share on other sites
rudedog 10 Posted March 12, 2015 Did you install the USB drivers? Share this post Link to post Share on other sites
signyouup 178 Posted March 12, 2015 Is the line the same direction as the blade moves? If so make sure the pinch rollers are closed Share this post Link to post Share on other sites
tuctucben 0 Posted March 12, 2015 signyouup, that turns out to be the problem. It was frustrating to troubleshoot at first, not knowing where to look. But, it turned out the paper wasn't being moved/rolled, so the line was being drawn, instead of an actual shape. Thanks everyone! Share this post Link to post Share on other sites