ken 0 Posted April 13, 2008 I have XP Pro as my Operating system. I have obtained & installed the bladeholder & blades as per previous helpful postings. I have found a posting for recognising the LP24 via the Device Mgr however XP seems to be different than decribed in the posting and I'm not "git'n-r-dun" Can someone please point me in the right direction? [MODIFICATION 2 MESSAGE] I found enough clues in the quick install instructions to be able to get it up and cutting. Share this post Link to post Share on other sites
haumana 1,220 Posted April 13, 2008 what exactly is happening? are you sending it to cut, but nothing happens? are you getting an error message, if so, what does it say? are you using the USB or the serial port? which cutter do you have selected in the cutter setup window? i think the cutter to choose is the creation pcut (since there is no LP listed). Share this post Link to post Share on other sites
kenimes 42 Posted April 14, 2008 Glad to hear you "got-r-done" Share this post Link to post Share on other sites
