eddieb378 41 Posted January 4, 2015 Just as the topic says is there a way to calibrate a heat press? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 4, 2015 I just did a search online and saw where you can calibrate a Knight heat press. You don't state what brand. Maybe do a search online for your brand... Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted January 5, 2015 I know a hotronix can be calibrated Share this post Link to post Share on other sites
eddieb378 41 Posted January 5, 2015 It is a uscutter perfect press and the temps are way off Share this post Link to post Share on other sites
eddieb378 41 Posted January 5, 2015 It burns me up cause the press is only 7 months old and I know it isn't top of the line but geeze! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 5, 2015 Is it this brand? http://www.uscutter.com/USCutter-Perfect-Press-15-x-15-Clamshell-Auto-Open-Heat-Press If so, here is how in the user manual. Note: There are two small port in front side of the digital display. If the real temperature is lower than digital controller shown, you can adjust the “hot port”; Clockwise to raise temperature; anticlockwise to reduce temperature. User manual http://www.uscutter.com//common/images/static/pdf/AOCLAM.pdf Share this post Link to post Share on other sites
eddieb378 41 Posted January 5, 2015 Where did you see the manual at Share this post Link to post Share on other sites
eddieb378 41 Posted January 5, 2015 Ok thank you mam my search skills must suck Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 5, 2015 Where did you see the manual at On the UScutter website. The page for this press being sold, and Support and downloads. Your welcome. Share this post Link to post Share on other sites
eddieb378 41 Posted January 5, 2015 Once again thank you so much 1 Share this post Link to post Share on other sites