scbuddney 4 Posted November 18, 2014 My USCUTTER MH365-MK2 (used for home use mainly) does not completely cut the letters. It leaves a very small uncut piece so weeding is extremely hard to do. It pulls the letter by a small uncut piece. any idea's? anybody else have this problem and found a cure? thank you for you thoughts in advance.. Share this post Link to post Share on other sites
KYSIGN 233 Posted November 18, 2014 it's a common problem with the value cutters. You need to add some over cut in your software. This will tell the cutter to cut past the end of the cut. 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 18, 2014 what he said - common with stepper motor cutters Share this post Link to post Share on other sites
scbuddney 4 Posted November 18, 2014 call me a dummy but what is overcut in my software? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 18, 2014 in newer flexi and scalp in the cutter section there is a feature called overcut - it tells the plotter to go a little past the end of the cut - thus finishing those tags 1 Share this post Link to post Share on other sites