Cutter-Ace 0 Posted October 28, 2014 Hello All, I have been cutting for quite some time now, but have ran into a sort of dilemma. I have a ProCut CR 1200. I was using CorelDraw X3, until it decided to crash on me. Was using it for years, and all of sudden it decided to just kill itself. I purchased CorelDraw x7 and now need to marry it my plotter. I see that the CR 1200 driver is available for download, but cannot find the plug-in for X7 anywhere. Is anybody able to assist in helping find where i can get the plug-in, or if i even need one at all? Share this post Link to post Share on other sites
Wildgoose 4,200 Posted October 28, 2014 You will be needing one but the plug-in is going to be to connect your X7 program to your cutting software. What software do you cut with? Many use SCALP (sure cuts a lot pro) or signblazer or SignCut Pro or flexi. Share this post Link to post Share on other sites