L79_Acadian 0 Posted September 30, 2014 Hi, im at work and thinking. How do i make the sign with two colors? Would i do each color in a seperate layer? Thanks Roger Share this post Link to post Share on other sites
Wildgoose 4,200 Posted September 30, 2014 That would be correct. Also a good idea to use some sort of registration mark to help align the two during install. I make a + mark or a diamond in each color stacked on top of each other so each color layer has one and then line them up for a perfect fit. After the install I pull the registration marks back off assuming I didn't just layer it in the shop which I also occasionally do with small stuff or buyer installs. Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted September 30, 2014 There are a few tutiorals on u tube for layering. But just as Wildgoose described above Share this post Link to post Share on other sites
L79_Acadian 0 Posted October 1, 2014 So this can be done with "sure cuts alot pro"? Thanks again for the help, Roger Share this post Link to post Share on other sites
Sal316 166 Posted October 1, 2014 So this can be done with "sure cuts alot pro"?Thanks again for the help, Roger Yes, you have the option to cut by color. Share this post Link to post Share on other sites
L79_Acadian 0 Posted October 2, 2014 Ok thanks for.the help. Im sure I will be posting on here again,lookung for.help Roger Share this post Link to post Share on other sites
L79_Acadian 0 Posted October 7, 2014 I guesd Im wee bit stupid. How do I get this software to cut in colors? I tried but didnt accomplish anything. I tried layers but I cant seem to get that working correctly either. Thanks Roger Share this post Link to post Share on other sites
express2100 154 Posted October 7, 2014 youtube is your friend at this stage of the game Share this post Link to post Share on other sites
