AtomicAce727 0 Posted April 14, 2014 I am planning on purchasing a Graphtec CE6000 this week and am curious what model blade and blade holder everyone uses for cutting Oracal vinyl. I know the Clean Cut blades are very common but WHICH part number do you use and which blade holder? What have you found to work best for small, intricate cuts? Thanks. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 14, 2014 1 factory blade holder and one extra ebay blade holder for the cb09 blade.. I use a 60 degree cleancut in every holder in the graphtec and Roland. not positive but I think Ross has the Chinese blade holders also 1 Share this post Link to post Share on other sites
rlvied 292 Posted April 14, 2014 like Scott said 60 in both machines Share this post Link to post Share on other sites
AtomicAce727 0 Posted April 14, 2014 Are you both using the blue blade holder? Is the blue blade holder what comes with the cutter? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 14, 2014 blue holder for one and the generic equivalent for the other. I use a second blade holder for metallics/reflectives as it is harder on blades - I just put last years main vinyl holder blade into that one after about a year as the metallics you don't cut as fine of stuff and it is still good for that stuff Share this post Link to post Share on other sites