RKP 0 Posted March 21, 2008 I drew out the lettering that i wanted scanned it and cleaned up the best i could in paint. imported into signblazer and i did a test cut to see where i was at. i have some rounded corners that are suppose to be sharp and some of the lines are not the right angle. i know what the angles are but when i hit the angle adjustment it tells me that i have to have two nodes to do this. well how do you highlight to nodes at the same time? how do i square the corners? I expect to see just nodes in each corner so i have remove the one in between because they are all straight lines when i remove the in between nodes the line becomes a arc that is why i just want to punch in the angles. Share this post Link to post Share on other sites
Benr98 40 Posted March 22, 2008 Square nodes make corners, round nodes make curves. I could help more if I could see the file. Jenny Share this post Link to post Share on other sites
RKP 0 Posted March 22, 2008 here is the file also on standard fonts like impact what funtion do you use to out line letters and i mean follow the whole outline of each letter in side and out like a pin striped letter? amp1.SBD amp1.SBD Share this post Link to post Share on other sites
Cutrix 0 Posted March 22, 2008 To change nodes, double click the image or just select it then click node edit on the tool bar. Then right click the node you want to change and pick which node (corner, curve etc.) you want to change it to. To pick more than one node, select your first node then shift click any remaining nodes. Hope this is helpful. Share this post Link to post Share on other sites
Benr98 40 Posted March 22, 2008 Here is your file, I think this is what you are looking for, hope it helps. Any additional questions, just ask, plenty of people to help ya. Jenny & Myron ampenergy.SBD ampenergy.SBD Share this post Link to post Share on other sites