tapster 0 Posted September 27, 2013 Forgive me for the newb question, but our condition presets are gone, and I'm re-doing them but I don't know what the FD in the Cut/Plot settings stands for. It doesn't match what's shown on the FC7000 and I can't find it in the manual. Thanks, Tap Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted September 27, 2013 can you post a picture of what you are referring to please? Share this post Link to post Share on other sites
bikemike 711 Posted September 28, 2013 Frig, Don't know. But mine is set at 35. Share this post Link to post Share on other sites
slice&dice 2,451 Posted September 28, 2013 Blade Rotation Control (GPGL command) The FD feature has to do with how smooth curves or circles are cut --a value of 30-35 should be good enough. M Move Mx,yO Relative Move Ox,yMP Move Polar MPr,θ[t]DP Draw Polar DPr1,θ1,r2,θ2,...rn,θn[t]EP Relative Draw Polar EPr1,θ1tOP Relative Move Polar MPr1,θ1tRP Radius Plot RPθ,l1,l2L Line Type LpB Line Scale Bl$ Font $n,(m)S Alpha Scale Sn,(m)Q Alpha Space Ql(k)R Alpha Rotate RθI Alpha Italic IpLP Label Position LPn[t]A Alpha Reset ARC Replot Character RCc,x1,y1,[P,]x2,y2,[P1,]...xn,yn[t]H Home H^ Offset ^x,y^P Offset Polar ^Px,y[,θdegrees[f][t]]J New Pen Jn,(m)! Speed !l[,n][t]* Pen Acceleration & Force *a,f[,n][t]FC Cutter Offset FCp,q[,n][t]FD Blade Rotation Control FDθ[t]\ Write Lower Left \x,yZ Write Upper Right Zx,y/ Rotate /x,y,θ> Clipping >x1,y1,x2,y2,...xn,yn[t]& Factor &p,q,rSO Set Origin SOnT Buzzer TnF Chart Feed Fl[t]G Gin GC Call Gin C? Read Offset ? etc. etc. etc. Share this post Link to post Share on other sites