brookieanne 0 Posted May 11, 2013 I'm trying to install Sure Cuts a Lot Pro and it's at the Install Driver point. I'm supposed to pick which cutter I have from a list, but it only says "LaserPoint". Does that apply to both I and II? Or is it not required? Please help! Share this post Link to post Share on other sites
maddog 12 Posted May 11, 2013 I'm guessing here, But if that is the only Driver for LaserPoint I would think it applies to I & II I'm pretty sure you will need a driver to operate with, I'm surprised that One or more of the Vinyl Guru's on this Forum hasn't replied to your question. Hope you get it sorted out, Don't get discourage for the most part this Forum is a plethora of Great help and Information for Newbies such as myself. Share this post Link to post Share on other sites
brookieanne 0 Posted May 11, 2013 Thanks maddog. I installed it that way, so we'll see how it goes... Share this post Link to post Share on other sites
jaybyrd 3,770 Posted May 11, 2013 Need to show LP2 and there is a driver required if I remember. I run an LP1 and 2 and if I forget to change in scalp does very weird things Share this post Link to post Share on other sites