mr_nibbles 0 Posted July 4, 2012 Hi All After using sign blazer with our new SC cutter and really enjoying using it does anyone know if any of the drivers (we use the UK version) work with the craft robo c200-20 our little craft cutter? your help would be appreciated Thank you Share this post Link to post Share on other sites
slice&dice 2,450 Posted July 4, 2012 Can't be sure if your CraftRobo is the same one that was being discussed previously in these forums, but try Graphtec 50. Also, there was a mention of using GP-GL, not sure if that's applicable in your case. http://forum.uscutte...raphtec-ce5000/ Share this post Link to post Share on other sites
top53 53 Posted July 4, 2012 I use Generic HPGL, no problems. Share this post Link to post Share on other sites
