SuperDrifter 0 Posted June 19, 2012 Greetings, fellow 'cutters'? I'm a newbie to this cutting world. I did not notice a USCutter SCSeries driver in FlexiSign, is there a generic one to use. THX Share this post Link to post Share on other sites
Dr12volt1338 116 Posted June 20, 2012 When I was setting up my VE cutter the driver wasn't included either so I downloaded it and put it in the driver folder within the SAi folder itself on my hard drive..... The folder is actually labeled output drivers. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted June 20, 2012 Greetings, fellow 'cutters'? I'm a newbie to this cutting world. I did not notice a USCutter SCSeries driver in FlexiSign, is there a generic one to use. THX Your vinyl cutter is a rebranded LiYU...SC Share this post Link to post Share on other sites
