OWJones 1,981 Posted June 3, 2012 First "real" cut with my brand spanking new Graphtec CE5000-60 using Corel Draw X3 with Cutting Master 2 plug-in. Also my first time to try and layer more than 2 colors. It didn't come out perfect, but that is entirely my fault - not the Graphtec's. Mirror is one of the el-cheapo ones from Dollar Tree, so I can afford to practice, and if it doesn't turn out, I can toss it in the trash and not lose sleep over it. I almost feel like a professional now! Share this post Link to post Share on other sites
C Lewis 6 Posted June 3, 2012 do i see some bubbles in that application Share this post Link to post Share on other sites
OWJones 1,981 Posted June 3, 2012 do i see some bubbles in that application Maybe... I didn't see them until I looked at the picture, they weren't really visible indoors, but daylight sure made them show up. I hit it with a hair dryer and smoothed them out a bit. Never had it do that before, but then I've never pulled the same vinyl off the backing multiple times - the red vinyl was pulled off a liner at least 4 times in the process of getting it layered and installed. That's my story and I'm sticking to it. Share this post Link to post Share on other sites
C Lewis 6 Posted June 3, 2012 Its all good. Practice. Just remember to use good consistent pressure applying & good tension on the premask Share this post Link to post Share on other sites
