MR kranwinkel 6 Posted June 12, 2011 HI EVERYBODY I HAVE A QUESTION CAN I CUT WITH MY Creation PCUT IN A LAPTOT WITH WINDOWS 7 ? Share this post Link to post Share on other sites
TurboRGV 0 Posted January 11, 2012 Yes you can. 32bit and 64bit. Share this post Link to post Share on other sites
BearlyRich 167 Posted January 12, 2012 But if you don't have a real serial port, you might want to invest in a Keyspan adapter. USB connections have always caused problems... Share this post Link to post Share on other sites
Signs Down Under 19 Posted January 12, 2012 Found out recently the CR models are not compatiable with 64 Bit OS... Only 32 Bit. Both Vista and Windows 7. Share this post Link to post Share on other sites
adcentre 0 Posted February 8, 2012 Hi there everyone, I'm also setting up pcut with laptop so I can go mobile so I can service remote areas that have no signwriters.. I'm a bit embarrased but I just joined as new member and can't work out how to post a question so can someone possibly give me a bit of a rundown on procedure, much appreciated, regards Lee. Share this post Link to post Share on other sites
MZ SKEETER 4,714 Posted February 9, 2012 Hi there everyone, I'm also setting up pcut with laptop so I can go mobile so I can service remote areas that have no signwriters.. I'm a bit embarrased but I just joined as new member and can't work out how to post a question so can someone possibly give me a bit of a rundown on procedure, much appreciated, regards Lee. Welcome..you are here on the forum, just ask the question.. Share this post Link to post Share on other sites