coateslr 0 Posted January 2, 2008 What's the minimum size sheet & roll width for the Copam 4050? I haven't tried lining up the vinyl yet with the arrow & enter keys, but when I do how much of the vinyl margins are needed to begin cutting. Let's say I have a 12" x 12" graphic that I want to cut, what's the minimum size of vinyl do I need to place in the cutter, if I am using scraps? Thanks Share this post Link to post Share on other sites
kenimes 42 Posted January 2, 2008 What's the minimum size sheet & roll width for the Copam 4050? I haven't tried lining up the vinyl yet with the arrow & enter keys, but when I do how much of the vinyl margins are needed to begin cutting. Let's say I have a 12" x 12" graphic that I want to cut, what's the minimum size of vinyl do I need to place in the cutter, if I am using scraps? Thanks At least 13 x 13" I would think to give youself enough room. Also keep in mind that the pinch rollers on the Copam must be in the colored sections to make good contact with the feed rollers. Share this post Link to post Share on other sites