strt8up 0 Posted December 30, 2007 I recently purchased a copam 2500 and just upgraded the elements to the pro. I recently downloaded eps format logos why is it that only part of the logo shows up when I outline it and it will not let me go in and add anything.Bare with me I am brand new at this computer stuff Share this post Link to post Share on other sites
haumana 1,221 Posted December 30, 2007 That sounds like SBE is seeing different levels to cut (I don't know what the technical term would be). I'm still a relative newbie myself, but I used to have the same problem. I found out there there some "white" spaces that were adding to SBE, but wasn't visible. I usually end up doing some kind of "weld" (punch through or total). You can also post your question to the Sign Blazer forum. http://www.signblazer.net/forum/index.php Good luck. Share this post Link to post Share on other sites
Jerry Bonham 1 Posted December 31, 2007 Hello I am unsure of your question. Can you email me the file? And then i will be able to help Jerry from SignBlazer, Share this post Link to post Share on other sites