TD-443 0 Posted May 21, 2010 First it started freezing in the middle of a piece and now when it goes back and forth and side to side it sounds like its dying. Also it doesnt seem to cut deep enough anymore. I plan on calling tech support monday but just curious if anyone has any ideas? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 21, 2010 if the stand isn't grounded to the cutter I am betting on a motherboard - I had one I fixed that did that. static builds up in the stand and discharges thru the cutting head. Share this post Link to post Share on other sites