MrMopar64 47 Posted May 10, 2010 I've got a deal to buy this unit for $200 but it is showing this error messages "Y-Axis error Realign rollers error" So the big question is it worth the money or will have most of a new one paid for by the time I fix it? I have no idea what parts or service cost for one of these Thanks for any advice you have MM64 Share this post Link to post Share on other sites
pyrophire 0 Posted May 10, 2010 Realigning rollers doesnt seem like its that complex of a repair, as to replacing motherboards/motors. Might come out to less than a new unit considering the 200+repairs. No clue who would do the repairs though lol Share this post Link to post Share on other sites
tinaski 11 Posted May 10, 2010 I will buy it for 300 That means rollers are not in correct place Make sure there in the blue marks above the rollers the graphtec rollers can't be placed any where it's kinda picky Share this post Link to post Share on other sites
MrMopar64 47 Posted May 10, 2010 No clue who would do the repairs though lol That be me MM64 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 10, 2010 are the pressure rollers below the green tape on the front of the unit like mentioned above? Share this post Link to post Share on other sites
MrMopar64 47 Posted May 10, 2010 Not sure... going to see the unit tonight MM64 Share this post Link to post Share on other sites
MrMopar64 47 Posted May 11, 2010 Ok here is the scoop.... Got it home and it had the realign rollers error... So I moved the roller down to the next blue strip and it acted fine so I took the covers off and cleaned the eyes on the carriage and did some testing it seems to be fine On start up it says press enter when I do it runs out to the first roller stops then goes to the second roller stops then returns back to the right rolls the vinyl a bit and stops I know nothing about this cutter is this how it should act? The guy had no manuals for it he said it was about 4yrs old BTW... when I push test it cuts a square with a triangle in the middle Thanks for any info you can pass on!! MM64 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 11, 2010 just go to the Graphtec website and download a user manual. Test cuts are done with a square and triangle. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 11, 2010 sounds like you are on your way and what a bargain! Share this post Link to post Share on other sites
tinaski 11 Posted May 11, 2010 You got it now just cut Share this post Link to post Share on other sites
Guest kenya Posted May 11, 2010 Sounds like it's working correctly to me. Good luck. Share this post Link to post Share on other sites
knucklehead 530 Posted May 11, 2010 The Graphtec is only going to cut in between the rollers. When you hit enter, the carriage moves over and back to measure the distance in between them. GOOD deal, enjoy it. Share this post Link to post Share on other sites
MrMopar64 47 Posted May 18, 2010 Well got the drivers and stuff installed... After making a few adjustments I sent a few projects to the cutter and it cut everything just like it should. Boy does it cut small compaired to my 721. MM64 Share this post Link to post Share on other sites
hockeygirl 30 Posted May 18, 2010 Congrats on the purchase! Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 18, 2010 and on the deal of the century Share this post Link to post Share on other sites