Guest matt72 Posted February 18, 2010 Hi ya'll how ya doing good here from the great northeast of Maine thaks for all the great info on this forum.... Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 18, 2010 Welcome from Michigan - yeh lots of great info around here - you can search and find most anything you ever wanted to know! Share this post Link to post Share on other sites
Guest matt72 Posted February 18, 2010 How about a serial # for my CorelDraw X3 i was sent 3 Cd in an envelope with no numbers and i can't install it ? any ideas Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted February 18, 2010 I would be contacting whoever you purchased from and getting the # or I would get my money back. sounds like counterfiet copies. Share this post Link to post Share on other sites
ms_sign 5 Posted February 18, 2010 Welcome from Fort Worth, Texas. Have fun, Jon Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted February 19, 2010 Hello and welcome from West Virginia Dan Share this post Link to post Share on other sites
Guest kenya Posted February 19, 2010 Welcome from Florida. Share this post Link to post Share on other sites
BCDPrints 0 Posted February 21, 2010 I'm in decision mode on the RX-24. The main question I have is about the down force to use for sand blasting. Does anyone how this device performs for sand blasting projects? Is the down force of 250 grams enough? Could use some advice. Your time is appreciated. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 21, 2010 yes it is Share this post Link to post Share on other sites
