fargo_182 0 Posted December 13, 2009 I was trying to cut an image that was 20" x 48" and when I go to cut, it only loads half of it, and only cuts half of it? The sizing for my vinyl is set right, the length is set for 300" anyways? When I do it smaller it is fine? Weird. Anyone come across this? It isn;t very intricate either it is a harley davidson logo. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted December 13, 2009 LOL, it probably won't cut it... "cause your cutter knows it's a trademark infringment making a Harley decal. LOL,, :thumbsup: Share this post Link to post Share on other sites
fargo_182 0 Posted December 13, 2009 Oh it will, just smaller haha I'm just trying to draw it, so someone can make wood blocks for a plaque out of it. X-mas present. Share this post Link to post Share on other sites
deth502 39 Posted December 13, 2009 make sure that it is all in the workspace on the draw page before you go to the cut page. you can adjust this in the workspace setup menu Share this post Link to post Share on other sites
fargo_182 0 Posted December 13, 2009 You are awesome! never even crossed my mind that'd be an issue. Thank you! Share this post Link to post Share on other sites
Jay2703 704 Posted December 13, 2009 You can toggle the setting on and off the limits what cuts to the workspace. The setting is in the Cutter setup. Jay Share this post Link to post Share on other sites