mr300s 1,272 Posted November 16, 2009 I read through the manual and many posts on here this morning and I still can't figure this out? It is probably easy, guess I am just doing something wrong? I am using 15" vinyl if I set my right roller to the start edge of the vinyl and then set the left roller to the edge of the left side and then hit enter, it will measure it like it is suppose to however it gets as close as I want it to on the strart (rt side) of the vinyl but I cannot get it to get any closer than about an inch away from the punch holes on the left side. On the right side I can get it right on top of the punch holes if I want. I tried playing with several setting on the cutter and it just doesn't seem to change anything? Any ideas what I am doing wrong? I have gone to plot area and expand but it doesn't appear to fix it? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted November 19, 2009 My cutting computer died last night so I can't go look but is there a setting in the cutting controller on the computer? Share this post Link to post Share on other sites
Guest Posted November 19, 2009 The cut head will not move past the pinch roller. Is the carriage stopping before it reaches the pinch roller? Share this post Link to post Share on other sites
mr300s 1,272 Posted November 19, 2009 The cut head will not move past the pinch roller. Is the carriage stopping before it reaches the pinch roller? Thanks Levi, I called Graphtec Tech support and got it. There was a bunch of other posts here yesterday? I had posted the out come not sure where they vanished to LOL.... Share this post Link to post Share on other sites
TShirtLover929 0 Posted February 14, 2012 mr300s, I know this is old but do you remember how you fixed it? I am having the same issue with it not cutting all the wy to the left side of the vinyl. It stops at the pich roller. Any help would be great. Share this post Link to post Share on other sites
Jay2703 704 Posted February 14, 2012 mr300s, I know this is old but do you remember how you fixed it? I am having the same issue with it not cutting all the wy to the left side of the vinyl. It stops at the pich roller. Any help would be great. I think Levi answered the question above. "The cut head will not move past the pinch roller." If you want it to go further, move the pinch roller. Share this post Link to post Share on other sites
mr300s 1,272 Posted February 15, 2012 I just ended up staying between them but there is an over ride feature that you can shut off. I think Carolyn (Skeeter) has the info.. Sorry wasn't much help Jay Share this post Link to post Share on other sites