SignGame 0 Posted June 15, 2009 I've been cutting alot of jobs on my PCUT , and I'm wondering what I need to do on my end to keep it clean and cutting correctly. Some tips on how to clean it would be great. Share this post Link to post Share on other sites
JoeCamaro 11 Posted June 15, 2009 Just dip it in a bucket full of soapy water. That should do the trick. Nah' just kidding. I think you just clean the blade with a lubricant. Share this post Link to post Share on other sites
SignGame 0 Posted June 15, 2009 I tried that soapy water trick and all that did was make it worse, I couldn't figure out why?, maybe I didn't use enough soap. HA,HA Share this post Link to post Share on other sites
JoeCamaro 11 Posted June 15, 2009 LOL, probably that. Well, always check your blade and make sure there are not pieces of vinyl stuck to it. If there are, cuts will be bad. I dont think there is much to it. Share this post Link to post Share on other sites
bayshorecreations 30 Posted June 15, 2009 I use the pressure washer every once in a while. Sometimes I will strap it to the bed of my truck and go through the car wash! Share this post Link to post Share on other sites
