Dr12volt1338 116 Posted May 7, 2009 I have a digital photo of a company logo I am trying to duplicate so I can cut it but I can not find the font anywhere is there some way I can get it from the digital photo I have or am I SOL?? PLEASE HELP!!! Share this post Link to post Share on other sites
acehole 1 Posted May 7, 2009 post the pic Im sure someone knows what the font is Share this post Link to post Share on other sites
Dr12volt1338 116 Posted May 7, 2009 Thanks for all of the help but I figured it out..... here is is for all who may have the same issue.... crop the text import it turn it to monochrome image vectorize and cut....... I am feeling pretty good I got it to work..... My other issue is I have never been able to get it to make complete cuts I have to cut by hand to finish a lot of the letters no matter what I am cutting Share this post Link to post Share on other sites
acehole 1 Posted May 7, 2009 Check ypur blade offset will be in the cut screen under setup Share this post Link to post Share on other sites
Dr12volt1338 116 Posted May 7, 2009 blade offset was at 0 mm Share this post Link to post Share on other sites
sarconastic 29 Posted May 7, 2009 offset should be 0.25 to start. then adjust up or down to get perfect closing. Kevin Share this post Link to post Share on other sites