poppie 0 Posted May 6, 2009 I just loaded Flexi and when I start it, I import a .bmp. When I click 'CUT' I get the error message "No cuttable object with current setting". I'm at a loss as to what this means. The same .BMP works fine with CorelDrawX3 and my laser.. Share this post Link to post Share on other sites
firemalt 10 Posted May 7, 2009 You can import just about anything into Flexi... but will only cut .eps files. Share this post Link to post Share on other sites
bayshorecreations 30 Posted May 7, 2009 you should be able to rasterize it and then vectorize, auto trace it in flexi Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 7, 2009 If you are using Flexistarter you cannot autotrace,, I did not see you specify which Flexi program you are using,,, Starter? Pro? Sign? Letter? I just know that if using Flexistarter, You have to import a design that is already vectorized. ie: AI file. EPS file etc. Share this post Link to post Share on other sites
poppie 0 Posted May 8, 2009 Thanx one and all. I think it's "Starter", 'cause I am !!! I was reading the document last night and it dawned on me that I needed a vector file. It's hard to cut all those little raster dots. I will re-export from CorelDraw in a .EPS and try it again. Share this post Link to post Share on other sites