lexiprice 1 Posted March 24, 2009 Does that make any sense. If I cut something the blade ends at the end of the cut- but if I don't adjust the blade by moving it then hitting origin the blade will go back to the beginning of the original cut cutting over what I just did. I've looked around here for an answer but couldn't find anything. It's got to be something that I'm just missing. Any help would be SO greatly apprecaited. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted March 24, 2009 the refine cutter itself does not support advance after cut. You have to reset after every cut. That is what I was told by both the software people and US Cutter tech support when I asked. It's a big pain in the butt too. Share this post Link to post Share on other sites
lexiprice 1 Posted March 24, 2009 it totally is! I have a broken ankle and my cutter is across the room from my computer. Getting up is no fun. Even without the crutches. Dang. Thanks for responding though! Share this post Link to post Share on other sites