Radioactiveman 2 Posted January 15, 2009 Hello, I am looking get back into the vinyl work, I did it when I was in High School and always wanted to get a plotter and do it as a kinda hobbie and a little extra cash on the side and see what it turns into. Im basicly looking to start off with numbers for boats, atv, sleds, derby cars, and show magnets. What would you guys recemend for a good starting plotter and program for resonably cheap. i would like to start small and progress as time goes on. Thank You very much any imput will be great. Share this post Link to post Share on other sites
kenimes 42 Posted January 16, 2009 I would go with the USCutter MH721 25". Comes with a stand and the software already, so you would just need a computer and some supplies to get started. Share this post Link to post Share on other sites
Radioactiveman 2 Posted January 19, 2009 cool thanks, ya i have a few in mind its just a matter of seeing what others say about them. Share this post Link to post Share on other sites
bayshorecreations 30 Posted January 19, 2009 Welcome from New Jersey! Enjoy the board! Share this post Link to post Share on other sites
2GuysSign 4 Posted January 20, 2009 Welcome to USCutter from New Jersey! Like ken said, refines are nice machines! Share this post Link to post Share on other sites
yoginaranjo 0 Posted January 22, 2009 Welcome to the forum from Southern California Share this post Link to post Share on other sites
Radioactiveman 2 Posted January 28, 2009 cool thanks guys, i cant wait to get one and start playing, i really like the show your work forum some really good work. one more question, what kinda of software should I stay clear of? I have it pinned down between either the laserpoint 24 or a SEIKI 34 in. but I dont know much about the seiki can anyone help?? I like the contour cut feature the laserpoint can do it with any program where the seiki comes with FlexiStarter v8.6 which has the contour setting. ANY HELP WOULD BE AWSOME I WANT TO GET CUTTING!!! Share this post Link to post Share on other sites
Dylan 0 Posted February 7, 2009 you can contour cut with the refine. there is step-by-step that has been posted, I followed the directions and it worked perfectly for me. Share this post Link to post Share on other sites