Long story short adobe pulled my license to cs6 after stating I owned a pirated serial number. I subscribed to the newest version of AI but my FC7000-75 plotter is too old to be compatible with cutting master plugin for illustrator. So i pulled out my old version of flexi 8 and figured i could use the product manager to cut jobs to my ancient plotter. The first test print went good, adjusted some speed settings, and when I went to cut again it started putting weird hooks on the sharp corners of all right angle edges. I reset the cutter back to factory settings and its still doing it. Any help would be appreciated. Trying to get the shop back up and running after moving to a new location. Everything was working perfect at my old location with cs6 and cutting master 2. I know the plotter is like 13-14 years old but it still runs like a dream. If i could just get this kink ironed out.... If i test from the plotter is cuts smooth, just printed the weird hooks on the edges when sending from flexi 8 with the product manager. Any help would be GREATLY appreciated!