Large Acrylic sign

[Large Acrylic sign]

I replaced a couple of panels on this Dr's office sign.  Roughly 4' x 6' back lit acrylic.  My first large acrylic sign.

Since I am only running an LP 24, I had a seem overlap for the circle (top to to bottom).

[introduction from the Seattle region]

I have been around and searching the posts for about a year, but with winter coming on I find myself getting into other opportunities with Signs, banners and graphics.  Since US Cutters is in my backyard I have found them to be a great resource.

See you around.

[Credit card Acceptor: Square]

I received mine in the mail a couple days ago. Haven't had a chance to use it yet. It's so cool and small!

How long did it take for you to get?

[Laserpoint 24" and Windows 7 Issue]

I am only using the 32 bit win 7.  So far it is working with the occasional unplug of the USB.

[Laserpoint 24" and Windows 7 Issue]

I agree.  PAIN.  Not liking it.  I did just try to take away the compatibility mode (XP SP3) and it would NOT cut.  So I turn it back on and it cut.

[Laserpoint 24" and Windows 7 Issue]

More fine tuning of the problem this morning.  I can cut out of sign cut once.  Then it hangs.  I then cancel the cut when it hangs.  I then unplug the usb and replug and the cutting works.  So is the problem in Sign Cut or is it the USB driver?

[Laserpoint 24" and Windows 7 Issue]

Ok guys I ran into the same problem.  I tried to cut out two copies of the same image and the machine started cutting wacky.  So I hit the kill switch so I wouldn't waste vinyl (started running the whole roll of easy weed). 

Needless to say I rebooted CPU and cutter.  So all fresh and I send one cut via SignCut Pro.  It cuts, try to send a second.  NO DICE.  Just hangs.  says 45+ minutes to do a 5 minute cut. 

I tried to kill SignCut pro, reboot, etc, etc.  Still only get one cut in.  So now with a hung set-up I went to sign cut pro and set the compatability mode to 'windows xp service pack 3' (no reboot) and the cutter starts to work.

That said, I am leaning on a driver issue.  Run compatability.  It should work.

[edit] I did one cut and it hung again.  Killed Sign Cut Pro, and it still did not cut.  So Killed Sign Cut Pro and unplugged USB.  Started Sign Cut Pro and replugged USB and it cut the vinyl.[edit}