Cal

Me three! Cal

Welcome aboard J - From your pic it looks like the offset might need tweeking. Also, be sure to unroll the vinyl before cutting so that you are not pulling directly from a tight roll. I just advance the vinyl through the cutter a little more than I will need and then send it back so that it is loosely wound on the roll. Use your pen to get your setup correct so that you do not waste vinyl while getting your settings correct. Good luck with it. What blade are you using, how did you set the blade depth, what speed are you cutting at, what is your blade pressure set at? Cal

$230 for a custom hat sounds kinda high Cal

Nice work! Cal

Welcome aboard Blaze. Sorry that I cannot be of much help, I have a mac. What happens when you hit the *test connection* in the middle block up there? I also note your Baud rate is set at 4800. Do a search on this forum for that. For some reason I am thinking I have seen here that it should be set on 9600? Good luck with it. I hope that it is a simple fix for you. This is a good cutter and will serve you well once you get it recognized. btw - it was working when purchased, right? Cal

I just shipped some glassware to CA. USPS was much cheaper than UPS... That said, when I took the package to the P.O. it was going to be quite a bit (but still cheaper than UPS). I repacked it in a flat rate box and shipped it for $17 & change. Cal

I second that! Cal

I guess I could pay off the wife*s debt... or at least make a dent in it! Cal

What is that font you are using OW? Not that I read it, mind you... Cal

Welcome aboard, Cal

A few years back the dash lights and several gauges in my wife*s Buick stopped working. A $500 fix according to the dealer. On you tube I watched a video and fixed the problem with $1.25 worth of Radio Shack resistors. Cal

Congratulations Dakota! Cal

Welcome aboard! Cal

Welcome aboard, Cal

Grabbed a copy also. Thanks, Cal

Welcome aboard, Cal

Welcome aboard, Cal

Congratulations and best of luck! Cal

I would say that you are in business now! Cal

Nice stuff Scott! Cal

Welcome aboard, Cal

Sue2 is good with lemonade, that is for sure! Cal

That is pretty darn cool right there. I would like to know more about the technique. Did you find a how-to video or was it trial & error? btw - walls and ceilings are seldom square... Cal

Look for a Merge or Weld option. Cal

Welcome aboard, you will get a lot of useful & helpful info here! Cal