-
Content Count
21,363 -
Joined
-
Last visited
-
Days Won
640
Content Type
Profiles
Forums
Gallery
Everything posted by Dakotagrafx
-
too old for me also
-
being it did it with the pen I would look for static to be the problem (although this time of year that gets better. Is your stand grounded to your cutter with a wire?
-
with the hp it is probably dye based - that would definitely do theat
-
Waz' the most exotic thing you have done with Starter?
Dakotagrafx replied to wetstuff's topic in Flexi
any graphic . . . -
hmmm I thought that was dirt on the adhesive
-
I didn't think signblazer had drivers for the bridge cutter
-
I would think anything that has a height of 23" could be cut sideways on a 24" machine
-
Welcome from Sunny Michigan
-
Where do I get registered to access support?
Dakotagrafx replied to DVMike's topic in Criticism and Complaints about USCutter
This thread and document from Paco has alleviated a lot of frustration http://forum.uscutter.com/index.php/topic,17489.0.html -
Thanks Bill
-
See american workmanship rules!
-
Bill I want that one!
-
nice to keep busy!
-
Thinking about opening a storefront, any thoughts?
Dakotagrafx replied to bayshorecreations's topic in General discussion
I agree - need the room to do what you want without the headache -
Waz' the most exotic thing you have done with Starter?
Dakotagrafx replied to wetstuff's topic in Flexi
Was it of me? that's a lot of vinyl LOL -
I personally use a teflon sheet with everything unless I am looking for more of a matte finish
-
definitely not Oracal
-
have fun - put the over 40 crowd on a trampoline - it is fun watching them discover that they have changed over time!!
-
on pre heating - always pre heat to get the excess moisture out of the garnet as it will cause problems with adhesion I have done a transfer and easyweed on the same side - I just do the higher heat (Transfer) item first and then apply the easyweed at the cooler temp
-
Big issues getting started !!!!!!!!!!!!!!
Dakotagrafx replied to DVMike's topic in USCutter Refine Cutting Plotter Support Requests
here - this will walk you thru everything http://forum.uscutter.com/index.php/topic,17489.0.html -
Running SignCut Pro with a Creation PCUT CT630 - Will not cut!! Please help!
Dakotagrafx replied to DreamCatcher's topic in Mac Users Board
have you submitted a support ticket yet?? -
definately different than the one I had - it was built like a tank and after selling it on my first sublimation job I thought I had made a big mistake - luckily it was the printer making the problems on the new one
-
Well Duh . . .all work no pay (or support). anyways I know there are 2 other mods!