Hi guys,
I am new to this forum and sublimation.
I'm attempting some sublimation on 20 oz skinny tumblers. The equipment I'm using is as follows :
sawgrass sg 500
Jetcol dhs paper ( have tried many types )
Original sawgrass ink
amazon heat press
When I press a tumbler I'm getting the wording looking like the ink has smudged. It's not a lot, but I'm a perfectionist and this really irritates me.
I press the tumbler for 60 seconds at 375 F , rotate rot180 degrees and press for another 60 seconds. I use butcher block paper as a waste paper.
I have tried peeling the paper hot and completely allowing it to cool before peeling . I seem to have better results allowing it to completely cool before removing paper.
I have tried lowering the pressure and increasing my pressure. The smudging appears better with a very low pressure .
Any suggestions would be appreciated.
Look at the I in " I am"
And
The I in " resilient "
