Leaderboard

I was bored the other day and found something at princess auto. That would be like the US northern tool or harbor freight. And I thought, HEY, that could work. So for $29 Canadian I got me a 10 roll storage rack. Not bad for a lumber storage rack.

Compromise, set it at *310-315 for the 20 seconds, you shouldn't have any problems, ez weed is pretty forgiving

Hi, What glitter material are you trying to cut? If it's the regular chunky glitter with a sticky backing then a 60 degree blade works best with a .50 offset. You should be in the 200 gram range with the down force. Always perform a test cut. A few other tricks that will help. Roll the material up after you remove it from the cutter. This separates the cuts lines so you can see them more easily. To ease the weeding process, you can also put the material on the lower platen of the heat press. I am always available for tech support. Kathleen the Siser PRO at kathleen.servais@siserna.com. Good Luck!!

Cliff it.