MDesigns 7 Posted January 16, 2021 as the subject states. Looking to know if its possible with the mac sc2 and SC4 software? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 16, 2021 Look up your cutter. https://support.uscutter.com/hc/en-us/categories/360002380391-Vinyl-Cutters It shows Scalp 3 so it should for scalp 4 Share this post Link to post Share on other sites
MDesigns 7 Posted January 17, 2021 looks like its possible. Thanks for the link. 1 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted January 17, 2021 Your welcome Share this post Link to post Share on other sites
MDesigns 7 Posted January 24, 2021 So I have had some success. Funny enough the people at Craft Edge said contact US cutter lol. Oh the old ping pong support game. Ill get it sorted eventually! I think I have a set of steps for any users who might be struggling as well. Share this post Link to post Share on other sites
MDesigns 7 Posted January 24, 2021 These directions were exactly what I needed. I tried to calibrate the machine myself initially. Which did work. But the method described here takes all the guess work out about the cutter offset! This was super helpful (wish I had remember to look here this morning!) Share this post Link to post Share on other sites
slice&dice 2,450 Posted January 24, 2021 Always wondered what that little red laser dot was for. Share this post Link to post Share on other sites