Sign in to follow this  
AigarsDL

Graphtec FC8600-160 Uneven Cutting Force

Recommended Posts

Hello!

I work with Graphtec FC8600-160 for about one year.

The problem is- Cutter use less pressure on very left  side of cutting job.

I use  53 inches- 137 cm.

It's very thick over laminated material.

I use special cutting knife for thick materials and it works pretty well, but I can not calibrate right pressure to cut all wok good.

If the Right side is very ok, then left side is less ok, and opposite...

 

May be some of had the same issue with other cutters or directly with FC8600-160?!

Thanks!

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this