KyleS 0 Posted May 21, 2017 This issue recently started. Whenever we start a cut, say on setting 5, it will cut the first object on the print on that setting, but once it jumps to the next one it will switch to setting 1 on its own. Has anyone had this issue and have a idea on how to fix it? Thanks for any and all help! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 21, 2017 Never heard of that. I never run from the settings on the cutter, I run every order from the Graphtec Cutting Controller using condition 9. Never had a problem. Easy to control everything from your computer. You might not like it. but I always have. Mine is an older FC... If you don't like that idea, Factory reset the cutter. see if that changes anything. That's all I can think of. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 21, 2017 if using a cutting program like flexi it has the ability in that program to change the settings on each job . . . . no idea what program you are using so no idea if that is it or not. also if you have the graphtec cut controller downloaded on your computer it can change it from the computer too Share this post Link to post Share on other sites
KyleS 0 Posted May 21, 2017 im using Cutting master for the processing of it. ill look to see if i changed any settings there Share this post Link to post Share on other sites