demabornholm 0 Posted January 23, 2016 Hi First of all, sorry for my bad English. I have had a Redsail RS720C cutter for a while and my computer just died so I had to buy a new one. But I can't get the cutter to cut like it did before. It can cut straight, but everytime I try to cut a round letter or something like that its not round but a Little edgy. Like if i if the knifes are bad (They are new and i tried several). Any ideas what to do? //Dennis Share this post Link to post Share on other sites
busterbay 326 Posted January 23, 2016 don't know what program you are using but look at the following: blade offset overcut baud rate some software programs also have resolution settings. Share this post Link to post Share on other sites
demabornholm 0 Posted January 23, 2016 I use Signcut pro. And I believe I have set it up right like the recommended setup. But I'm not sure. Share this post Link to post Share on other sites
mb20music 760 Posted January 23, 2016 Hi First of all, sorry for my bad English. I have had a Redsail RS720C cutter for a while and my computer just died so I had to buy a new one. But I can't get the cutter to cut like it did before. It can cut straight, but everytime I try to cut a round letter or something like that its not round but a Little edgy. Like if i if the knifes are bad (They are new and i tried several). Any ideas what to do? //Dennis Can you post a picture of your settings and also an example picture of the circle after it is cut. Share this post Link to post Share on other sites
demabornholm 0 Posted January 25, 2016 I can't post Pictures in the message but you can see them in the links below http://imgur.com/J98MLVK http://imgur.com/Uh1h9gY http://imgur.com/gHHEIFi Share this post Link to post Share on other sites
demabornholm 0 Posted January 25, 2016 This is just weird. I just tried the plotter on my parents computer. And there is no problem on that one. Anyone heard of this before??? Share this post Link to post Share on other sites
pads war 0 Posted August 1, 2019 red light blinking on ONLINE botton on redsail rs720c. and the plotter locks up. any help? Share this post Link to post Share on other sites
Johnny007 0 Posted August 23, 2019 On 8/1/2019 at 11:51 AM, pads war said: red light blinking on ONLINE botton on redsail rs720c. and the plotter locks up. any help? i dont know if this is the problem but when the cutter reaches the boundary it locks up and the red light flashses . it happened some times and i understood that the problem is with the position of the blade . like when it reaches the corner it locks up.. sorry my bad english i dont know the terms used for this machine... Share this post Link to post Share on other sites
Pablito777 0 Posted November 25, 2020 On 1/23/2016 at 8:06 AM, demabornholm said: Hi First of all, sorry for my bad English. I have had a Redsail RS720C cutter for a while and my computer just died so I had to buy a new one. But I can't get the cutter to cut like it did before. It can cut straight, but everytime I try to cut a round letter or something like that its not round but a Little edgy. Like if i if the knifes are bad (They are new and i tried several). Any ideas what to do? //Dennis Is posible send me driver please. ? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted November 25, 2020 10 minutes ago, Pablito777 said: Is posible send me driver please. ? You can get it from Redsail http://www.redsailcnc.com/download.html Share this post Link to post Share on other sites