Bunky67 0 Posted February 24, 2014 I picked up a MH871 Cutter today, and I coudn't see it power up, So I got it home and powered it up and the Fan runs, the control panel screen lights but no words, and the 3 led's are lit, and none of the functions on the control board work, Where do I start to troubleshoot this? also does this take a special blade holder or is there aftermarket ones available ? Also how do you tell if the cutter is MKI or MKII ? Share this post Link to post Share on other sites
slice&dice 2,450 Posted February 24, 2014 I picked up a MH871 Cutter today, and I coudn't see it power up, So I got it home and powered it up and the Fan runs, the control panel screen lights but no words, and the 3 led's are lit, and none of the functions on the control board work, Where do I start to troubleshoot this? also does this take a special blade holder or is there aftermarket ones available ? Also how do you tell if the cutter is MKI or MKII ? Hopefully you paid under $100. and it appears to me that your motherboard is shot. The blade holder is available from USCUTTER. You might be able to determine the model # by talking to support (the serial number should provide them a clue). Share this post Link to post Share on other sites
Bunky67 0 Posted February 28, 2014 Yes I only paid $40 so I will be good if only the motherboard is bad Can someone tell me what is used for screws to hold the control panel to the top of the plotter? The screws in mine are gone Thanks Share this post Link to post Share on other sites