Sc serie 34' problem

[moutoun 0]

Hello all, my Sc series is not set corectly..i think...

Sooo.. Here my problem

First one, where the cutter start to cut and the end point, the ending is a bit off ,

Second, straight line have little wave , normal?

And the last one, roller make print in the vinyl and stay on the vinyl!

Thanks!

[Dakotagrafx 7,297]

pretty much normal for the "value cutters" with the stepper motors - the marks left by the rollers will disappear when applied

[TT57 135]

I had bad cuts with my first one. SC series. Call support. They are very helpful and will walk you through it. I had to get a new one after only 1 week and now it cuts great. May be a lemon.

[Dakotagrafx 7,297]

LOL may be the same one.

[jaybyrd 3,770]

Almost spit up my coffee lol