smallon733 1 Posted October 20, 2012 So i have made many successful cuts but tonite qhen i tried to cut out a graphic the cutter started going everywhere then started cutting. It got about 30% done then went off and stated feeding and cutting at a diagonal line amost through the whole roll before i stopped it... any ideas. I am using SCpro and i have a mh 871 series cutter. 1 Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 20, 2012 Sounds like your using USB connection,Put it on a serial cable, or keyspan adapter. Share this post Link to post Share on other sites
mb20music 760 Posted October 20, 2012 ^ what she said or it may need grounding, or maybe both Share this post Link to post Share on other sites
iphone911 9 Posted October 23, 2012 I agree with above Share this post Link to post Share on other sites
j4str 9 Posted November 9, 2012 ive seen where this happens when you send the plotter too much information. Like if you trace a really big picture and there is like 500,000 anchor points. Share this post Link to post Share on other sites