tuba4 0 Posted October 30, 2008 Why does vinyl not want to come onto the trans tape all of a sudden. I changed the blde already. Are there better vinys than others. Sometimes it will even peel off some of the paper with it when I try to physically remove it with a pick. I squege it properly. mabe the new trans tape I bought from signwarehouse Alan Share this post Link to post Share on other sites
Jay2703 704 Posted October 30, 2008 Your blade is out too far. Share this post Link to post Share on other sites
kenimes 42 Posted October 31, 2008 Yes, if the blade is cutting too deep in to the backing, it will make it harder for the vinyl to release from the backing. Share this post Link to post Share on other sites
azdecals 3 Posted November 24, 2008 I didn't post the orginal question, but I'm having the same problem. I thought it was because I changed from 651 to a differnt vinyl (a sample). I did adjust the blade a bit when I changed vinyl and it is cutting into the backing. It was getting pretty frustrating trying to apply my test decals. Thansk you two for the info. Share this post Link to post Share on other sites