Agencep3 0 Posted October 28, 2008 Hi everybody, we notice that our copam 2500 have an acceptable cutting speed in straight line but really slow down in curves and round shapes. Is there a specific reason (driver or setting) or is it just normal. Our roland cx500 run a lot faster doing curves at the same speed setting. Thks Agencep3 Share this post Link to post Share on other sites
kenimes 42 Posted October 28, 2008 Normal, it slows down on curvers, probably because of the stepper motors, whereas the Roland is probably built with a servo motor. Share this post Link to post Share on other sites
