iceman 0 Posted October 20, 2008 I just got a Vista Laptop and I am unable to get Signcut X2 (newest version downloaded) to cut anything through the USB to serial coverter. I had the old converter that didnt work with vista so I went to Radio Shack and purchased one that was vista compatible ($35) loaded the drivers it, and setup the right port in signcut, etc. I use illustrator and send to signcut and when I go to cut all it does is cut a straight line about 8 in. long and stops... any thoughts? This cutter worked fine through my old dead pc with the other connection.... Share this post Link to post Share on other sites
ff-extreme 6 Posted October 21, 2008 I had the same problem using my copam and flexi. ended up using and older computer just for the cutter with the old connection. I design on my new laptop and use a flash drive to the old computer Share this post Link to post Share on other sites
iceman 0 Posted October 21, 2008 bummer... I was really hoping this would work. Especially since I dropped $35 on a new cable... I will mess around with it some more before I give up. It is obviously a communcation issue to the cutter. I also need to get it working so that my signcut software will continue to work as the laptop has the internet and authorized the license... Share this post Link to post Share on other sites