secas 0 Posted October 12, 2008 I am trying to create a sign consisting of text with the shadow effect. In order to get the registration marks I make 2 squares, duplicate them, make one of them the color of the shadow and the color of the initial text and then put them on top of each other in the program. THE PROBLEM when I do the gray#6 square it shows up as a seperate grey #6 than the shadow. When it comes time to cut I end up with 2 different grey #6 to cut separately. I tried to group and combine them but I always end up with 2 different cuts for the same color. Oddly enough this never happens with the primary color. I actually got it to work once but can't seem to do it again. If there is an easier way or any tips on cutting registration marks would be greatly appreciated. Thanks in advance for your help Share this post Link to post Share on other sites
SmokinZMan 2 Posted October 12, 2008 If you hold the CTL key you can select more than one color to cut. The way I do it is just put a mark in a color I know will not be used and then select it with each cut selection. Hope this makes sense Bryan Share this post Link to post Share on other sites
secas 0 Posted October 12, 2008 Makes perfect sence and it works great. If I only asked sooner I would have saved hours. I can't possibly thank you enough. Have a great night, Shane Share this post Link to post Share on other sites
SmokinZMan 2 Posted October 13, 2008 No problem I'm glad I could help. Bryan Share this post Link to post Share on other sites
mobby 1 Posted October 14, 2008 A good suggestion mobby http://www.computerandlaser.com.au/SB_Support.htm Share this post Link to post Share on other sites