mitchrp 0 Posted October 12, 2008 When trying to center the laser to the registration marks with the jog window in Signblazer, is there a way to make the joggin increments smaller? When trying to set up my first contour cut the window came up for the right registration mark and when I clicked on an arrow key it moved too far.... with several attempts of moving the vinyl manually I was able to get the cut done... and it did a pretty darn good job !!! Help please !! Share this post Link to post Share on other sites
SmallSigns 23 Posted October 13, 2008 When using the keypad to jog the cutter -- hit the #5 and this will shift to small jogs - hit it again to go back to the larger jogs. Good luck Share this post Link to post Share on other sites
mobby 1 Posted October 14, 2008 In SB, you can type in the jog ammount. beware if using cut manager, it does not support USB also go here http://www.computerandlaser.com.au/SB_Support.htm Share this post Link to post Share on other sites
mitchrp 0 Posted October 14, 2008 Thanks Mobby and SS. Mobby - where and how do you type in the increment values ? Share this post Link to post Share on other sites
mobby 1 Posted December 8, 2008 In the bottom RH corner. It is called "nudge" Also available in settings / preferences Share this post Link to post Share on other sites