Stoke 0 Posted September 30, 2008 Oh most definitely. Its running. Share this post Link to post Share on other sites
kenimes 42 Posted September 30, 2008 I am at a loss. Any way you could snap a short video of it in action when this is happening? Share this post Link to post Share on other sites
BlackMesa 0 Posted October 6, 2008 I still have the same problems as described. As for the vinyl lifting up, the only time I have had this problem is on one certain graphic and what I did to solve it was to lower the pressure. The 120 is great on other graphics, but on this certain one, anything above 75 and one part of the graphic will get pulled up. The blade pressure is fine at 75 for the rest of the graphic also. As for the cuts not closing on text, I still have that problem, even after going to a 60 degree blade and resetting everything within Signblazer to what has been recommended. Even a node check reveals all of the letters are closed. Share this post Link to post Share on other sites
Stoke 0 Posted October 6, 2008 My issues are gettign better. Just learning more and understanding more is a big help. I've spent the past few days just tweaking and experimenting and things seem some better. Share this post Link to post Share on other sites