mikeT 0 Posted July 12, 2008 hi,my name is mike and i will be asking some dumb ?'s until i figure out this new cutter and software. my wife has a klic -n -kut (redsail) with signlab software. the manual for 24 lazer is not to good. my first ? is what are the little red buttons on the inside of the cutter for? thanks Mike Share this post Link to post Share on other sites
RegisG 0 Posted July 12, 2008 Welcome. Don't know witch cutter you have but, the red buttons on each side stop the motor when the head hits the side (usually because home is set toooo close to where the program is driving the head) Welcome Share this post Link to post Share on other sites
routesmith 0 Posted July 14, 2008 welcome to the group, I have one of the 24" Laserpoints as well, if you have any 's LMK Wayne Share this post Link to post Share on other sites
rebjr 0 Posted July 15, 2008 Welcome to the gaggle. Share this post Link to post Share on other sites
Guest fivestar Posted July 16, 2008 Welcome to the forums. Share this post Link to post Share on other sites