smoovlatino 0 Posted April 17, 2007 Hello, I have the 721 cutter and am using SignCut. On certain graphics, the cutter will cut shapes two or three times in the same pass occassionally pulling the graphic off the paper. What can I do to prevent this? To better describe the problem, let me provide an example: tonight, while cutting a family crest graphic, I observed the cutter cut a circular pattern once, then, instead of continuing on with the rest of the graphic, it "retraced" the same circular pattern again. When it "retraced" the pattern, it pulled the vinyl from the backing and stuck to the blade housing. Share this post Link to post Share on other sites
TaterNuts 3 Posted April 17, 2007 Can you post the file so that we may take a look at it? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted April 17, 2007 when you go to cut,in the dialog box,there should be a setting that says: "nr of turns,objects(reflecting vinyl)." It should say 1. If it says 2 it will cut twice. If it's not that,I haven't got a clue. Share this post Link to post Share on other sites
smoovlatino 0 Posted April 17, 2007 I found what is was! The light grey outline was being cut as well as the solid black outline. I just deactivated the grey outline, and now it only cuts once. Share this post Link to post Share on other sites
BannerJohn 1,324 Posted April 17, 2007 well,I was gonna say that too. LOL just kidding. Good that you posted back so others might learn.That's what this forum is all about! Share this post Link to post Share on other sites