White teflon strip required for CT630 Creation Pcut cutter

[kainth.c.s 53]

Hi everyone

 

Has anyone got any idea wherein I can get the teflon strip for this cutter which is about 2 mm thick and less than 8 mm in width?

The strip need not be glued or fixed using double sided tape but inserted into the channel made next to the ruler.

The strips I got from the company are 1.5 mm but the one on the cutter is 2 mm. Thus the vinyl is not cutting properly.

 

Any help would be greatly appreciated

[haumana 1,220]

Try Aliexpress.com   That's here I had to go to buy a replacment blade holder for my (first generation) LaserPoint.  That was the only place I could find one.

Though, I would recommend that if cutting strip is just simply too low, then to put tape or something else that will just build up the height, then put the strip over that.

[kainth.c.s 53]

Ali express is where I got these strips from. If I put something underneath the 1.5 mm strip to increase its height, it may not fit into the channel as the strip is not glued but inserted into the channel.