SIZING FROM COREL X3 TO SIGNCUT

[ScooterD 0]

Hi All, So when I bring an image from Corel to signcut, I change setting to inches, and adjust size in "image" it still try's to cut huge. Do I need to adjust size in corel?  Any help?  Newbie...

Scott

[wg_kjell 0]

Hi,

when you change size SignCut-X2 will keep that size just as the kind of measurement you have chosen. At least that is what should happen as you close SignCut-X2 properly. I mean, than it should remember at next time to use inches.

When it does not change I assume that you have the "Locked scale" parameter set? However as it is active the normal size setting options in the Control panel should be grayed out, which makes that explanation less plausible?

So I suggest that you reset SignCut-X2 to default parameters, all over to see if that solves the problem? To do that, cick the Settings menu and choose "Sign < 3mm".

Then close SignCut-X2 and open it once again and make a new trial.